Operating instructions

System manual ImageTile 47
checkbox next to “Enable the DualView device?”, and click “Next”.
If you do not wish to enable DualView simply click “Next” to
continue.
Figure 20
9. The screen shown in figure 21 displays the device(s) that will be
installed. If you want to change your selection, click Back and you
will see the previous screen. To begin installation, click “Next” to
continue. If you want to end the installation without installing the
driver, click “Cancel” and the wizard will exit. Once you click
“Next”, you cannot cancel the driver installation.
Figure 21
10. Prior to beginning the installation, the BarcoMed Driver Install
Wizard will warn you that while the driver is being installed your
display may flicker. Click “OK” to continue (see figure 22).
BarcoMed software driver installation