Operating instructions

System manual ImageTile 45
the user clicks “Finish” or “Cancel”. Select the devices you want
to install, click “Next”.
Figure 16
If you selected a device with an existing driver, the existing driver’s
version will be compared against the version of the driver you are
installing. If the existing driver’s version is newer than the one you
are installing, the Wizard will warn you that the current driver is
newer than the one you are installing (see figure 17). If you
choose to continue, your existing driver will be replaced. Click
“OK” to continue.
Figure 17
If you want to change your selection, click “OK” to continue and
then click “Back” on the next screen.
8. Your selection on the screen shown in figure 20 will determine if
DualView is enabled or not. DualView allows a dual head imaging
board to display two separate desktops, one for each display
instead of a single virtual desktop that spans across both displays.
DualView is a feature that is automatically supported by Windows
XP. However, BARCO has provided a means for you to enable this
functionality while running Windows 2000. Figures 18 and 19 on
the next page shows the difference between running without and
with DualView enabled under Windows 2000.
BarcoMed software driver installation