Operating instructions

System manual ImageTile 44
Continue to click “Cancel” until Windows 2000 stops launching
the “Found New Hardware Wizard - Video Controller”.
4. Windows 2000 may advise you that it has finished installing all the
new devices in your system and that you must reboot your system
in order for the changes to take effect. If it does, Click “No”.
5. Insert your ImageTile Software CD into your computer’s CD drive.
The “BarcoMed Driver Installation Wizard” should start
automatically. If it doesn’t start within 5 minutes, browse the
contents of your ImageTile Software CD and double click on the
file: “NTDriverInstaller.exe” to start the wizard.
6. Click “Next” on the Wizard’s Welcome Screen to continue or
“Cancel” to exit the wizard (see figure 14).
Figure 14
If you select “Cancel”, a dialog box (figure 15) will open asking
you to confirm cancellation of the install process. If you choose
“Yes”, the Wizard will exit. If you choose “No”, the Wizard will
continue normally.
Figure 15
7. The Device Selection Screen’s dialog box should show only those
devices physically installed and supported by the Barco graphics
device driver on your ImageTile Software CD (see figure 16 below).
If there are no Barco devices installed or if the driver on your
ImageTile Software CD does not support the installed devices, the
dialog box will be empty, and program will exit when
BarcoMed software driver installation