Operating instructions

System manual ImageTile 41
Note: The system shown in figure 12 is a single BarcoMed 3MP2FH
Imaging Board, no 3
rd
party VGA card configuration, your system may
look different.
Installing the Driver Using the Windows NT 4.0 Display
Properties Control Panel
SPECIAL NOTE: Prior to installing the BarcoMed Display Drivers you
MUST install the BarcoMed Imaging Board(s), connect the ImageTile
display panel(s) to the card(s) and turn the ImageTile display panel(s)
on. Refer to the Hardware Installation section of this manual for
instructions on installing the BarcoMed Imaging Board(s) and
connecting them to the ImageTile display panel(s).
To install the BarcoMed 3MP2FH Imaging Board Windows NT 4.0
Display Driver, log in using an account with administrator privileges
and follow these steps:
1. Double Click on the “My Computer” Icon.
2. Open the “Control Panel” Folder.
3. Double Click on the “Display” Icon.
4. Click on the “Settings” Tab.
5. Select “Display Type”.
6. Select “Change”.
7. Select “Have Disk”.
8. Insert your ImageTile Software CD into the appropriate drive or
browse to the location of your driver and Click “OK”.
9. Select the appropriate BarcoMed Imaging Board (See table
below.).
emaNdraoB emaNrevirD
HF2PM3HF2PM3
Click “OK”.
10. You will see a message saying that this is a Third Party Driver and
asking if you wish to proceed. Click “Yes”.
11. The driver files will be copied onto your system.
12. You will receive a message saying the driver is successfully
installed. Click “OK”.
13. Close the “Display Type” dialog box.
14. Close the “Display Properties” dialog box.
BarcoMed software driver installation