Operating instructions

System manual ImageTile 40
If you are installing one 3MP2FH in portrait mode, select
“3072x2048x256”. This will set the output resolution for each
display to “1536x2048x256”.
For a two-card, quad-head configuration, select
“6144x2048x256”.
Select “OK”.
4. Select the “Test” button and click on “OK” to test the display. You
will be asked if it displayed correctly. If the test pattern displays
correctly, select “Yes”. If not, select “List all Modes” and try
selecting another mode.
5. In order to apply your changes, you need to click on the “OK”
button in the “Display Properties” dialogue box but this button will
not be visible because you are running in VGA mode. Select “OK”
by pressing “CTRL” + “Enter”.
6. You may be asked if you want to restart your computer. Select
“Yes”. Even if Windows does not ask you if you want to restart
your computer, you must restart it and boot normally for your
changes to take effect.
7. When your system restarts, select the “NT Version 4.00” option
(NOT the VGA Mode option). Log in as usual.
If you wish to change the number of ImageTile display panels you are
using, see the “BARCO Metheus Configuration Tab” chapter of this
guide.
Figure 12: The Windows NT 4.0 Display Properties Control Panel
after the drivers have been installed and the resolution set.
BarcoMed software driver installation