Operating instructions

System manual ImageTile 39
Figure 10
6. Remove your ImageTile Software CD from its drive and click
“Yes” to confirm reboot (see figure 11).
Figure 11
7. When your computer restarts, select “NT Version 4.0 (VGA
Mode)”. Log in using an account with administrator privileges.
Setting the Resolution of Your ImageTile Display Panel
After you have logged in using an account with administrator
privileges per step 7 above, Windows NT will launch the “Invalid
Display Settings” dialog box with the following message:
“ A new graphics driver has been installed. The default
display resolution from the driver has been temporarily used
by the system. Please use the Display option in the
Windows NT Control Panel to select your preferred display
resolution.”
1. Click “OK”.
2. The “Display Properties” dialog box will appear. Click on the
“Settings” tab, select “List all Modes” (see figure 12 on the next
page).
3. Select a resolution from the list that is correct for the maximum
number of display adapters installed (even if you will later
configure for less than the maximum number of displays supported
by your configuration). For example:
BarcoMed software driver installation