Operating instructions

System manual ImageTile 35
SOFTWARE INSTALLATION
Overview
The BarcoMed 3MP2FH Software Installation section has been
divided into three sections, one for each of the three supported
versions of the Windows operating system. They are: Windows NT
4.0, Windows 2000 and Windows XP.
In addition to the device drivers for your BarcoMed imaging boards,
your BarcoMed Software CD also includes several additional tools.
They are: The Barco Metheus Configuration Tab, the Barco Metheus
Hardware Configuration Tab and the Barco Metheus DPMS Screen
Saver. The Barco Metheus Configuration Tab and the Barco Metheus
Hardware Configuration Tab are automatically installed with BarcoMed
imaging board drivers. The Barco Metheus Configuration Tab helps
you manage the special features of your BarcoMed imaging boards.
The Barco Metheus Hardware Configuration Tab gathers information
about the BarcoMed imaging boards and your system that is useful
when diagnosing problems. The Barco Metheus Hardware
Configuration Tab can also be used to update the firmware on the
AURA video chipset based BarcoMed imaging boards. The Barco
Metheus DPMS (Display Power Management Signaling) Screen Saver
is an optional tool which must be installed separately. The Barco
Metheus DPMS Screen Saver allows the user to set power and
monitor saving features for medical monitors driven by BarcoMed
Imaging Boards. At the end of the work day, the monitor will enter
certain DPMS states as requested by the imaging board. This is
accomplished through standardized signals between the monitor and
imaging board. Instructions for installing the Barco Metheus DPMS
Screen Saver are included in the chapter on the Barco Metheus
DPMS Screen Saver.
BarcoMed software driver installation