Operating instructions

System manual ImageTile 21
hctiwS noitcnuF
NEAGV.)NOsitluafed(daeHyramirPehtnoAGVselbanE
NESOIBSOIBOEDIVehtdaerotSOIBmetsySehtswollA
.)NOsitluafed(
LAMRON.)NOsitluafed(etatSdraoBslortnoC
KLCTNI.)NOsitluafed(kcolClanretnI
etihwehtnehwnoitisopNOehtnierasehctiwsehT
ehtfopotehtsdrawotdenoitisopsihctiwsredils
.draob
Using the VGA Capabilities of the BarcoMed 3MP2FH
Prior to installing the BarcoMed 3MP2FH, decide if you are going to
use its on-board VGA capabilities.
If you are, check the setting of the VGA switches on the graphics
board. (See SW1- VGA switches, figure 1.) By default, VGA should
be enabled.
If you decide to use a separate VGA monitor as your boot monitor,
you must disable the on-board VGA capabilities of the BarcoMed
3MP2FH by setting switches #1 and #2 on the 3MP2FH board to the
“off” position. The two switches are labeled “VGA EN” and “BIOS EN”
respectively. Use a pen or small flat bladed screwdriver and move the
white slider switch toward the bottom of the switch (towards the
numbers).
NOTE: To use multiple 3MP2FHs in a single host with VGA enabled,
you need to enable VGA on only ONE of the 3MP2FHs and disable
VGA on ALL other BarcoMed boards.
Examples of PCI Slots
Although the BarcoMed 3MP2FH has a 64 bit PCI connector, it
functions as a 32 bit board. It may be installed in either a 32 bit or 64
bit slot with no loss of functionality. Figure 2 illustrates the types of
slots so that you can correctly identify which one to use for the
3MP2FH.
Imaging board installation