Operating instructions

System manual ImageTile 124
2 Select "Reboot Sentinel"
3 Sentinel now reboots, allowing you to change the Internet Protocol
address properties.
More information about this, you can find in the previous section
"Setting up Sentinel".
If you do not wish to change the address settings
You may have selected the "Reboot Sentinel" function without the
intention to assign a new IP-address. In that case, you do not have to
do anything.
Sentinel will reboot. After two minutes, the ImageTile will be
reconnected to the network automatically, using the old IP-address.
After the connection has been re-established, your web browser may
display a blank page. Refresh the Sentinel page in your browser by
re-entering the ImageTile IP-address in the web browser's address
field.
ImageTile web control