Operating instructions

System manual ImageTile 123
ImageTile web control
2 Select the check you wish to perform.
You can perform the following checks:
Get the firmware version ......Returns the firmware versions for each
tile
Check the backlight .............Returns the backlight reserve for each
tile, compared to the maximum backlight
reference of 500 cd/m², calibrated.
Get the luminance ................Returns the luminance value for each tile
Get the display runtime ........Returns the total runtime of each tile
Get the backlight runtime .....Returns the runtime of the backlight of
each tile
Check I-Guard......................Returns the status of each tile's I-Guard
(OK or Not OK)
Note: If the ImageTile is in power-save mode (e.g., stand-by), the
following functions will fail: Check Backlight, Get Luminance, and
Check I-Guard.
REBOOTING SENTINEL
The purpose of the Reboot Sentinel function is to assign a new IP-
address to the ImageTile.
More information about this, you can find in the previous section
"Setting up Sentinel".
To reboot Sentinel
We assume you have established connection with the ImageTile and
your web browser displays the Sentinel main page.
Proceed as follows:
1 In the Sentinel main page, click on "Sentinel Init". The Sentinel init
page appears.