Operating instructions

System manual ImageTile 117
INTRODUCTION
The ImageTile Web Control allows you to remotely connect to the
ImageTile panel and to:
- Check a number of the ImageTile's parameters
- Define a warning and error tolerance for some of the ImageTile's
parameters
- Enter the mail addresses to which a mail must be sent
automatically in case one of the ImageTile's parameters exceeds
the warning or error tolerance
- Enter the Sentinel "From" address that will appear on the warning
and error mails
Important:
The ImageTile Web Control will exhibit problems when it runs
simultaneously with MediCal Pro. Therefore, close MediCal Pro before
starting the ImageTile Web Control.
CONNECTING TO THE IMAGETILE
Establishing a connection
Once you have assigned an IP-address or host name to the
ImageTile (see previous section "Setting up Sentinel"), you can
remotely connect to it by using a web browser.
To connect to the ImageTile, proceed as follows:
1 Make sure MediCal Pro is not running.
2 Start a web browser (Microsoft Internet Explorer 5.5 or higher).
3 Enter the panel's IP address or host name.
The Sentinel main page appears.
ImageTile web control