Operating instructions

System manual ImageTile 112
Changing the address properties
When the ImageTile already has got an IP-address, you can change
the Internet Protocol address properties using the Sentinel Setup
software.
For more information about the different possibilities in entering the
address properties, please refer to the previous chapter "Entering
address properties for the first time".
To change the address properties, proceed as follows:
1 Make sure the connected computer supplies an image to the
ImageTile panel.
2 Make sure the computer is connected to the network.
3 Make sure the ImageTile is connected to the network, using the
network connector on the ImageTile itself.
4 Start your web browser and establish connection with the
ImageTile panel.
If you do not know how to do this, please first read the section
"ImageTile Web Control" further in this manual.
5 Reboot Sentinel by using the Reboot Sentinel function on the
ImageTile web control pages (see next section).
Tip: Alternatively, in order to reboot Sentinel, you can unplug the
mains power plug from the ImageTile, and then plug it in again.
6 Wait for at least 40 seconds for Sentinel to start up (happens in
background).
7 Run the application "sentinel.setup" from the
Start -> Programs -> Sentinel menu.
The Sentinel Network Configuration dialog appears.
8 Change the address properties. You have two minutes to change
the data in the Sentinel Network Configuration dialog.
After two minutes, the program will try to establish connection
automatically.
If you did not succeed entering the correct data within two minutes, or
in case the connection failed, repeat this procedure.
In case of remaining connection problems, please refer to the chapter
"Connection problems" below.
Sentinel setup