Operating instructions

System manual ImageTile 108
Entering a fixed IP-address
Proceed as follows:
1 Make sure the connected computer supplies an image to the
ImageTile panel.
2 Make sure the ImageTile is connected to the network, using the
network connector on the ImageTile itself.
3 Run the application "sentinel.setup" from the
Start -> Programs -> Sentinel menu.
The Sentinel Network Configuration dialog appears.
4 Check the option No DHCP server available.
5 Enter valid addresses in the fields IP-address, Subnet Mask and
Gateway. The addresses must be in the format nnn.nnn.nnn.nnn.
For the correct addresses (also those below) consult your network
administrator.
6 Enter valid addresses in the fields Primary DNS and Secondary
DNS.
7 Enter the IP-address of your mail server in the field Mailhost IP.
8 Enter a name for the ImageTile panel in the field Hostname. Enter
the name of your computer network domain in the field Domain.
The domain name must be in the format xyz.com.
9 Click on OK.
Sentinel setup