Instruction manual

ImagePRO-II • User’s Guide 69
4. Menu Orientation
Configuring Outputs
~ Channel — If you have the 3D/Dual Channel option installed, you can
select the channel to which these offsets will apply. If you are using the
standard ImagePRO-II, this option is not available.
~ H Offset — Sets the horizontal offsets, in increments of +/- one-half line,
in pixels. The range depends on the output format.
~ V Offset — Sets the vertical offsets, in increments of +/- one-half frame.
The range depends on the output format.
• Status — The current status.
With the 3D/Dual Channel mezzanine installed and the system mode set to Dual2K, the
Genlock Submenu also includes two lines for setting the Channel A and B source.
Figure 4-48. Genlock Submenu in Dual-Channel Mode
In this mode:
• CHA Source defaults to the selected input. It can also be set to Freerun,
Ext(ernal), or any of the other inputs.
• CHB Source defaults to Lock to A. It can also be set to Freerun.
p~îáåÖ=~å=lìíéìí=`çåÑáÖìê~íáçå=
To save the custom output configuration of the selected output, select Save Config from
the Output Menu. The settings are saved in non-volatile memory, and the save persists
across power cycles.
With the 3D/Dual Channel mezzanine installed and the system mode set to Dual2K, the
Out Save Config Submenu appears when you select Save Config from the Output
Menu. Out Save Config supports saving your configuration files on a per-channel basis.
The configuration is saved on every output mapped to the selected channel.
Figure 4-49. Out Save Config Submenu (sample)
G E N LO C K
> C H A Source In 6(SD I-2)
C H B Source Lock to A
H /V O ffset >>
HD-15 SC Phase n/a
Comp SC Phase n/a
C H A Status N o Sync
CHB Status Locked
Note
Output settings revert to the last saved state when you power
up the ImagePRO-II. If you do not save your settings, they
are not restored.
OUT SAVE CONFIG A
> Channel A
Save Config