Instruction manual

68 ImagePRO-II • User’s Guide
4. Menu Orientation
Configuring Outputs
Figure 4-46. Image Flip — Vertical
The options are H, V, H+V, and Off. The default setting is Off.
• Strobe Mode — This option turns the strobe effect On or Off. The default setting
is Off. If Strobe Mode is on, the timing of the strobe’s flash effect is determined by
the Strobe Rate setting.
• Strobe Rate — This option sets the timing of the strobe’s flash, when Strobe
Mode is on. The range of this rate is adjustable from 2 to 100 frames. The default
setting is 2 frames.
^Äçìí=dÉåäçÅâ=pÉííáåÖë
The Genlock Submenu tells the ImagePRO-II which signal to lock on, when you want to
synchronize to a source signal. The following illustration shows the options on the Genlock
Submenu.
Figure 4-47. Genlock Submenu
The Genlock Submenu options are:
• Source — This option selects the Genlock source from the following values:
Freerun, External, or an Input button. External sync supports both NTSC/PAL
blackburst and HD tri-level syncs.
• H/V Offset — This option sets the Horizontal and Vertical offsets separately.
When you select this option, the Genlock Offset Submenu appears, and
provides the following options:
GENLOCK
> Source Freerun
H/V Offset >>
Status Freerun