Instruction manual

64 ImagePRO-II • User’s Guide
4. Menu Orientation
Configuring Outputs
~ RGB, 4:4:4, 24 bit
~ RGB, 4:4:4, 30 bit
~ RGB, 4:4:4, 36 bit
~ YCbCr, 4:4:4, 24 bit
~ YCbCr, 4:4:4, 30 bit
~ YCbCr, 4:4:4, 36 bit
The default setting upon format change is:
~ RGB, 4:4:4, to the maximum bit depth supported, as given in the EDID
information
The default setting if EDID information is invalid or not present is:
~ RGB, 4:4:4, 24 bit
The 36-bit rates may not be available if output timings are not compatible.
• SDI 1 and SDI 2 — SDI 2 is only available when the dual-channel mezzanine is
installed. The options are:
~ YCbCr, 4:2:2, 30 bit
~ RGB, 4:4:4, 30 bit
~ YCbCr, 4:4:4, 30 bit
~ RGB, 4:4:4, 36 bit
~ YCbCr, 4:4:4, 36 bit
pÉííáåÖ=lìíéìí=bÑÑÉÅíë
The Output Effects Submenu sets properties of the output image, such as contrast and
brightness, color balance, and sharpness. From the Output Menu, select Effects to
access this menu.
Figure 4-39. Output Effects Submenu
If the 3D/Dual Channel mezzanine is installed and the system mode is set to Dual2K, this
menu includes the option to change these settings for each channel.
OUT EFFECTS
> Contrast 100
Brightness 100
Color Balance >>
Gamma 1.0
Monochrome Off
Invert Off
Sharpness +0
Flicker Reduce n/a
Image Flip Off
Strobe Mode Off
Strobe Rate n/a