Instruction manual

ImagePRO-II • User’s Guide 61
4. Menu Orientation
Configuring Outputs
• V Position — Adjusts (in lines) the offset of the start of the output active area from
V sync.
• V Active — Adjusts (in lines) the vertical size of the output active area.
• V Sync — Adjusts (in lines) the V sync width.
rëáåÖ=`çãéLpJsáÇÉç=^Çàìëí
By selecting Comp/S-Vid Adjust from the Output Menu, you can adjust the output
encoder, which produces composite and S-Video outputs. The following illustration shows
the Comp/S-Vid Adjust Submenu.
Figure 4-35. The Comp/S-Video Adjust Submenu
On this menu, there are two options, HD-15 Pedestal and Comp Pedestal.These options
enable or disable the 7.5 IRE pedestal on NTSC composite output. These options are not
available for PAL video.
The Pedestal settings are either On or Off. The default setting is On for NTSC video.
pÉííáåÖ=lìíéìí=póåÅ
The Output Sync Settings Submenu lets you specify the sync types for selected outputs.
Access this menu by selecting Sync Settings from the Output Menu.
Figure 4-36. Output Sync Settings Submenu
• For DVI Sync, HDMI Sync, and DP Sync, the available options are:
~ +H+V
~ +H-V
~ -H+V
~ -H-V
The default setting for DVI Sync, HDMI Sync, and DP Sync is +H+V.
COMP/S-VID ADJ
> HD-15 Pedestal Off
Comp Pedestal Off
Note
These options apply only to outputs that support composite
and S-Video formats.
OUT SYNC SETTINGS
> DVI Sync +H+V
HDMI Sync +H+V
DP Sync +H+V
HD-15 Sync SOG/Y
HD-15 SOG/Y Tri-level