Instruction manual

60 ImagePRO-II • User’s Guide
4. Menu Orientation
Configuring Outputs
^ÇàìëíáåÖ=lìíéìí=qáãáåÖ
From the Output Menu, select Timing Adjust to display the Output Timing Adjust
Submenu. On this submenu, shown in the following illustration, you can change the
selected output’s total, active and sync settings, and reposition video on the output.
Figure 4-34. Output Timing Adjust Submenu (sample)
In dual-channel mode, the Out Timing Adjust Submenu includes a field for selecting the
channel to work with.
In either mode, your settings:
• Do not result in cropping the image
• Do not change the image aspect ratio
• Must be within the range of timings supported by the output display, to avoid loss
of signal
• Update the output Area of Interest
On this menu:
• H Total — Adjusts (in pixels) the total pixel count per line for the selected output.
• H Position — Adjusts (in pixels) the offset of the start of the output active area
from H sync.
• H Active — Adjusts (in pixels) the horizontal size of the output active area.
• H Sync — Adjusts (in pixels) the H sync width.
• V Total — Adjusts (in lines) the total line count per frame.
Note
All but the most advanced users are advised to avoid
changing the output timing values.
OUT TIMING ADJUST
> H Total 2200
H Position 192
H Active 1920
H Sync 88
V Total 1125
V Position 41
V Active 1080
V Sync 5
OUT TIMING ADJUST A
> Channel A
H Total 2200
H Position 192