Instruction manual

ImagePRO-II • User’s Guide 59
4. Menu Orientation
Configuring Outputs
2. If you have the 3D/Dual Channel mezzanine installed, and the System Mode is set
to Dual2K, select a channel to work with, or accept the default setting of All.
3. To change the horizontal size of the AOI, select H Size and turn the ADJUST
knob counter-clockwise. Press SEL when the image is placed correctly.
4. To change the vertical size of the AOI, select V Size and turn the ADJUST knob
counter-clockwise. Press SEL when the image is placed correctly.
5. To change the horizontal position of the AOI, select H Pos and turn the turn the
ADJUST knob counter-clockwise. Press SEL when the image is placed correctly.
6. To change the vertical position of the AOI, select V Pos and turn the ADJUST
knob counter-clockwise. Press SEL when the image is placed correctly.
7. If required, repeat steps 2 through 6 for the second channel.
8. To revert all your changes to their default settings, select Reset.
For information about setting an Area of Interest on a per-channel basis, refer to “Setting
the Area of Interest in Dual-Channel Mode” on page 110.