Instruction manual

ImagePRO-II • User’s Guide 57
4. Menu Orientation
Configuring Outputs
Figure 4-28. Adjusted Area of Interest
To adjust the Area of Interest, you use four settings on the Area of Interest Submenu,
shown in the following illustration. You can also restore the default AOI.
Figure 4-29. Area of Interest Submenu (sample)
In this menu, the following settings are available:
• H Size — Determines the width (in pixels) of the Area of Interest. This setting
must be equal to or less than the H Active setting of the output timing. The
following illustration shows an image after adjusting only the H Size.
Figure 4-30. H Size Adjustment
• V Size — Determines the height (in lines) of the Area of Interest. This setting must
be equal to or less than the V Active setting of the output timing. The following
illustration shows an image after adjusting only the V Size.
AREA OF INTEREST
> H Size 850
V Size 1080
H Pos 0
V Pos 0
Reset