Instruction manual

54 ImagePRO-II • User’s Guide
4. Menu Orientation
Configuring Outputs
lìíéìí=jÉåì=cìåÅíáçåë=~åÇ=pìÄãÉåìë
All Output Menu functions and submenus are discussed in the following sections:
Setting the Output Format
Setting the SDI Type
Using Output Auto Config Setting ColorSpace, Sample Rate, and Bit Depth
Viewing Output EDID Information Setting Output Effects
Setting the Area of Interest About Genlock Settings
Adjusting Output Timing Saving an Output Configuration
Using Comp/S-Video Adjust Restoring Output Configuration Default Values
Setting Output Sync
pÉííáåÖ=íÜÉ=lìíéìí=cçêã~í
The Output Format is the first setting on the Output Menu. This option sets the resolution
and frame rate at which you drive your projector or display. With the 3D/Dual Channel
mezzanine installed and System Mode set to Dual2K, the Output Menu includes this
information for both channels, as shown in the following illustration.
Figure 4-24. Output Menu in Dual-Channel Mode
When you change the output format, you also change the following settings:
• Output colorspace, based on the format you select
• Sync settings, based on the format you select
• Genlock and H/V offsets, which reset to 0
• The default Area of Interest, which resets to match the output’s active area. For
more information, refer to the section Setting the Area of Interest
on page 56.
 To change the output format, use the following procedure:
1. On the Output Menu, scroll to the format field and press SEL.
2. Scroll to the format you want using the ADJUST knob, then press SEL again. The
output is not updated until you press SEL.
To minimize synchronization problems, select a frame rate that is consistent with
your input sources.
 Example: If you are using 59.94 NTSC video inputs, running the output at
the same rate reduces frame-rate conversion artifacts.
rëáåÖ=lìíéìí=^ìíç=`çåÑáÖ
Extended Display Identification Data (EDID) is a data structure that an output display
uses to describe itself to a video source. The EDID can include information such as the
manufacturer’s name, a serial number, product type, timings supported by the display,
display size, and other data.
OUTPUT
>CHA 1280x720p @60
CHB 1280x720p @60
Output Auto Config >>