Instruction manual

52 ImagePRO-II • User’s Guide
4. Menu Orientation
Configuring Outputs
`çåÑáÖìêáåÖ=lìíéìíë=
The Output Menu enables you to configure the ImagePRO-II’s outputs and save your
settings if you wish. This section provides detailed information about setting up and using
outputs. To quickly position and size video on an LED wall or monitor, refer to Setting up
an LED Wall on page 101 of this chapter.
lìíéìí=jÉåì=qêÉÉ
The following figure illustrates the Output Menu tree.
Note
The Area of Interest, Timing Adjust, Effects, Genlock,
Save Config, and Reset Config submenus include
references to channels when the 3D/Dual Channel
mezzanine is installed and the system mode is set to Dual2K.
For the sake of brevity, these references are not shown here.
Similarly, when the mezzanine is installed and the system
mode is set to 3D, the 3D output options shown on the
following menu tree are available.