Instruction manual

ImagePRO-II • User’s Guide 45
4. Menu Orientation
Configuring Inputs
Figure 4-14. Edge Timing Adjust Submenu (sample)
Using this menu, you can set the exact locations of the active video edges, when 1:1
Sample is Off. For the right and left edges, the values are in pixels, and the position is
relative to the start of H Sync. For the top and bottom edges, the values are in numbers of
lines, relative to the start of V Sync.
Because 1:1 Sample is off, the image is oversampled, and the image quality may be lower
than when 1:1 Sample is turned on.
pÉííáåÖ=fåéìí=`çåíê~ëí=~åÇ=_êáÖÜíåÉëë
From the Input Menu, select Contrast to change the contrast of the selected input. Select
Brightness to change the brightness.
For both Contrast and Brightness, the adjustment range is in percentages, from 25% to
150%. The default setting for both parameters is 100%. Use the ADJUST knob to scroll
through the range, and press SEL to select a value.
pÉííáåÖ=fåéìí=`çäçê=_~ä~åÅÉ
From the Input Menu, select Color Balance to change contrast, brightness, hue, and
saturation values for the selected input. The Input Color Balance Submenu appears. The
values for contrast, brightness, and saturation are in percentages. The values for hue are in
degrees.
Figure 4-15. Input Color Balance Submenu
EDGE TIMING ADJUST
> Right Edge 2460
Left Edge 592
Top Edge 85
Bottom Edge 803
Note
When making active area adjustments, turn on the Output
Raster Box, and align the input image with all four edges of
the box. To turn on the raster box, refer to the Working with
Test Patterns section on page 70.
INPUT COLOR BALANCE
> Red Contrast 100
Red Brightness 100
Green Contrast 100
Green Brightness 100
Blue Contrast 100
Blue Brightness 100
Hue +0
Saturation 100
Reset All