Instruction manual

12 ImagePRO-II • User’s Guide
2. Hardware Orientation
ImagePRO-II Rear Panel
rëáåÖ=cêçåí=m~åÉä=_ìííçåë
Pressing a front panel button once causes that button to light up. If the button is associated
with a menu system, the display shows the top-level menu for that button. For example,
pressing SEL at the Status Menu displays the Setup Menu. If the button performs a
function, that function begins. For example, pressing ESC exits a menu or cancels an
operation immediately.
There are three button states:
• Lit – Button is selected.
• Dim – Source or logo is present but not active.
• Not lit – Button is not selected.
fã~ÖÉmolJff=oÉ~ê=m~åÉä
The following figure illustrates the ImagePRO-II rear panel.
Figure 2-6. ImagePRO-II Rear Panel
19
3
6
1
4
7
5
9
10
12
13
14
18
11
2
17
16
8
15
100-240 V AC 50-60 H z 2a
1
2
5
In SDI Loop
SDI Out
Composite Out
In 3 HDM I
In Universal DV I-I Loop
In Universal Analog Loop
Ethernet
HDMI Out
DVI-D Out
Analog Out In Genlock LoopDP Out
In 4 DP
In SDI 6
In SDI Loop
SDI 2 OutS3D In S3D Out
Audio I/O
1) AC Connector 10) Composite Video Output
2) Ethernet Port 11) DVI-D Output
3) Input 1 — DVI-I Input with Loop-through 12) Universal Analog Output
4) Input 2 — Analog Input with Loop-through 13) HDMI Output
5) Input 3 — HDMI Input 14) DisplayPort Output
6) Input 4 — DisplayPort Input 15) SDI-2 Output
7) Input 5 — SDI-1 Input with Loop-through 16) 3D Sync In
8) Input 6 — SDI-2 Input with Loop-through 17) 3D Sync Out
9) SDI-1 Output 18) Genlock Input BNC with passive Loop-through
19) Audio Mezzanine