Instruction manual

ImagePRO-II • User’s Guide 11
2. Hardware Orientation
ImagePRO-II Front Panel
fåéìí=_ìííçåë
Input buttons 1 through 5 correspond to the five standard input connectors on the rear
panel. These buttons select the source signal that you want to display.
Figure 2-5. ImagePRO-II Input Buttons
The sixth button is reserved for use with the optional 3D/Dual Channel mezzanine.
• Press Input Button 1 to select the source on the DVI (digital or universal analog)
connector.
• Press Input Button 2 to select the source on the HD-15 (universal analog)
connector.
• Press Input Button 3 to select the source on the HDMI connector.
• Press Input Button 4 to select the source on the DisplayPort connector.
• Press Input Button 5 to select the source on the SDI-1 connector.
• Press Input Button 6 to select the source on the SDI-2 connector, when the
3D/Dual Channel mezzanine is installed.
For details about supported resolutions and HDCP compatibility for each input, refer to the
“Input Video Connectors
” section on page 13 of this chapter, or to the “Input
Specifications” section of Appendix A, on page 161.
qÜÉ=ildl=_ìííçå
The LOGO button beneath the input buttons can serve as an additional image source.
Using LOGO, you can capture, import, and store a still output frame in non-volatile
memory, then transition to and from that still frame. For more information about using
LOGO, refer to the” Using a Logo or Internal Black
” section of Chapter 4 on page 96. For
more information about transitioning, refer to the “Setting Transitions
” section on page 83.
qÜÉ=_i^`h=_ìííçå
The BLACK button transitions the display to and from black. For more information about
BLACK, refer to the “Displaying Internal Black
” section of Chapter 4 on page 100.
qÜÉ=cow=_ìííçå
Pressing the FRZ button temporarily freezes the displayed video. If FRZ is lit, the following
actions turn it off:
• Pressing FRZ again
• Pressing the input button for the displayed image
When you freeze an image, the PAN/ZOOM button is not operational, and the Input Setup
and Views menus are not accessible.
6
SDI-2
2
3
HDMI
5
SDI-1
1
DVI-I
4
DP
2
HD-15
Note A customer-supplied DVI to HD-15 adapter is required to
connect analog video to the DVI connector.
LOGO
BLACK
FRZ