Instruction manual

ImagePRO-II • User’s Guide 211
`K==réÖê~ÇáåÖ=cáêãï~êÉ
Upgrading Firmware Using the Web Interface
A message informs you if a new firmware version is available. To install the latest
version over the internet, refer to the following section, Automatically Upgrading
Firmware Using the Web Interface.
If you wish to install a different version, refer to the section of this chapter titled
Selecting a Firmware File to Upload with the Web Interface on page 211.
If you are not connected to the internet, a message prompts you to check the
connection.
^ìíçã~íáÅ~ääó=réÖê~ÇáåÖ=cáêãï~êÉ=rëáåÖ=íÜÉ=tÉÄ=
fåíÉêÑ~ÅÉ
 Use the following procedure to automatically upgrade ImagePRO-II software with the
Web Interface:
1. Open a compatible web browser, and enter the ImagePRO-II’s IP address in the
address bar. The web page shown in the following illustration appears.
Figure C-5. System Information Tab
This page provides information about the current firmware version. In addition,
there are two options:
~ Auto Upgrade
~ Upload Firmware
2. To detect and upload new firmware automatically, click Auto Upgrade.
If a new firmware version is available, it loads and a confirmation message
appears. This process may take several seconds.
pÉäÉÅíáåÖ=~=cáêãï~êÉ=cáäÉ=íç=réäç~Ç=ïáíÜ=íÜÉ=tÉÄ=fåíÉêÑ~ÅÉ
 Use the following procedure to select a firmware version to install using the Web
Interface:
1. On the System Information tab, click Upload Firmware.
The System Firmware Upgrade window appears.