Instruction manual

210 ImagePRO-II • User’s Guide
`K==réÖê~ÇáåÖ=cáêãï~êÉ
Upgrading Firmware Using the Web Interface
Figure C-3. USB Code Upgrade Menu
4. Scroll to the file you want to use, and press SEL.
5. Scroll to Upgrade and press SEL again.
A progress message appears.
When the file is loaded, the ImagePRO-II powers down and reboots.
réÖê~ÇáåÖ=cáêãï~êÉ=rëáåÖ=íÜÉ=tÉÄ=fåíÉêÑ~ÅÉ=
Before you begin the firmware upgrade, ensure that your PC, laptop, or mobile device uses
one of the following operating systems:
• Windows
®
XP, Windows
®
Vista™, or Windows
®
7
• Mac OS
®
X
• Red Hat
®
Linux
®
You must also know the IP address of your ImagePRO-II unit, which you can find by
selecting Setup > System > Ethernet.
`ÜÉÅâáåÖ=Ñçê=^î~áä~ÄäÉ=cáêãï~êÉ=réÖê~ÇÉë
 To determine whether a new version of the ImagePRO-II firmware is available, use the
following procedure:
1. Verify that the ImagePRO-II has internet access. Contact your system
administrator if necessary.
2. Select Setup > Firmware Upgrade > Web Upgrade. The submenu shown in the
following illustration appears.
Figure C-4. Web Firmware Upgrade Submenu
3. Select Check.
USB FIRMWARE UPGRADE
> ImagePRO2_10_5.tar.gz
Upgrade
(FAT filesystem only)
Note
Do not remove the flash drive or power down the
ImagePRO-II until the firmware file is uploaded.
WEB FIRMWARE UPGRADE
> Check >>
Verify internet access
before continuing.