Instruction manual

ImagePRO-II • User’s Guide 209
`K==réÖê~ÇáåÖ=cáêãï~êÉ
Upgrading Firmware Using the USB Port
Figure C-1. Format Removable Disk Window
6. Then click Start. A message appears, warning that data will be erased during the
formatting process.
~ Click OK to continue.
~ Click Cancel to halt the process.
7. If you click OK, a confirmation message appears after a few seconds. The flash
drive is now ready to use.
If you click Cancel, you can delete data or download it to the computer, then retry
the formatting operation.
mÉêÑçêãáåÖ=íÜÉ=cáêãï~êÉ=réÖê~ÇÉ=rëáåÖ=íÜÉ=rp_=mçêí
 To upgrade the ImagePRO-II firmware via the USB port, use the following procedure:
1. Insert the flash drive into the ImagePRO-II’s USB port.
2. Select Firmware Upgrade from the Setup Menu. The Firmware Upgrade
Submenu appears.
Figure C-2. Code Upgrade Submenu
3. Select USB Code Upgrade. The menu shown in the following illustration appears.
Note
Upgrading software with the USB port requires the
“ImagePRO2_xx_xx.tar.gz” file to be within a directory named
ImagePRO2.
If the software upgrade downloaded from the Barco website
was unzipped directly to the USB drive, this directory will
have been created for you.
FIRMWARE UPGRADE
> USB Upgrade >>
Web Upgrade >>