Instruction manual

ImagePRO-II • User’s Guide 199
B. Remote Control Protocol
ImagePRO-II Remote Commands
• Audio Connectors (aconn):
0=HDMI
1=DP
2=SDI1
3=SDI2
4=Ext AES
• Analog Input Level (inlevel):
0 = +4dBu (Professional)
1 = -10dBV (Consumer)
• Analog (analogmap) / AES (aesmap) Channel Map:
0 = Channel A
1 = Channel B
• Test Tone Mode (testtone):
0 = Off
1 = On
 Example: To set mode to Input Map
AUDIO --mode 0
 Example: To set Input Map for HDMI to Mute
AUDIO --conn 2 --imap 0
 Example: To set Direct Map to Ext Analog
AUDIO --dmap 1
 Example: To get audio input status for HDMI
AUDIO --status --aconn 0
OK
 Example: To set Analog Audio Map to Channel B
AUDIO --analogmap 1
^rafllrq
• Description: Audio Manger Output Settings. For parameter details, see below.
• Parameters:
--och (channel 0,1)
--level (set analog output level: +4 dBu, -10dBV)
--delay (set delay: -1 for auto, 0-300ms)
--rate (set audio rate: 48kHz, 96kHz )
--bitdepth (set bit depth: 16, 20, 24)
• Query Format:
AUDIOOUT? --och #
• Query Response:
AUDIOOUT? --och # --level # --delay # --rate # -depth
#