Instruction manual

ImagePRO-II • User’s Guide 197
B. Remote Control Protocol
ImagePRO-II Remote Commands
• Required parameters:
--con (connector), for input video format
--och (output channel), for output video format
--itype (input type), for commands to DVI input settings
• Parameters:
--con (connector): 0-4
0 = DVI, 1 = HD15, 2 = HDMI, 3 = DP, 4 = SDI1, 5 = SDI2
--och (output channel): 0-1, for output commands
--itype (input type): 0 = digital, 1 = analog
--new (new format name): Use " " around the format name. Use
VFSTDLIST to get the standard format names. This command option
changes the format to “new format name.”
--enum (new format enum): Use VFSTDLIST to get the standard format
names.
--reset (reset default timing)
--name (format name): This command option simply renames the current
format.
--hsync (horizontal sync)
--hact (horizontal active)
--hfp (horizontal front porch)
--hpos (horizontal position)
--htot (horizontal total)
--vsync (vertical sync)
--vact (vertical active)
--vfp (vertical front porch)
--vpos (vertical position)
--vtot (vertical total)
• Query Format:
VFS --?
• Query Response: Video Format settings in the following format:
VFS --name "format name" --hsync (hsync) --hact (hact)
--hfp (hfp) --htot (htot) --vsync (vsync)
--vact (vact) --vfp (vfp) --vtot (vtot)
^ìÇáç=oÉãçíÉ=`çãã~åÇë
^rafl
• Description: Audio Manger Settings. For parameter details, see below.
• Parameters:
--mode (set audio mode)
--imap (set audio input map)