Instruction manual

ImagePRO-II • User’s Guide 193
B. Remote Control Protocol
ImagePRO-II Remote Commands
ea`m
• Description: HDCP Settings
• Required parameters:
--icon (input connector), for input connectors
--ocon (output connector), for output connectors
• Parameters:
--icon (input connector): 0, 2, 3
0 = DVI, 2 = HDMI, 3 = DP
--ocon (output connector): 0, 2, 3
0 = DVI, 2 = HDMI, 3 = DP
--enable (HDCP enable): 0 = disable, 1 = enable
• Query Format:
HDCP --icon (connector) --?
• Query Response: HDCP settings in the following format:
HDCP --enable (HDCP enable) --auth (Authentication
Status 0/1)
pqjdo
• Description: Logo Management Settings
• Parameters:
--deleteall: Delete Logo
--eraseall: Erase Logo (destructive)
--captureall: Capture Logo
--infoall: Logo H/V information
• Query Format: n/a
pvp
• Description: System Settings
• Parameters:
-r (type): 0 = Soft, 1 = Factory, 2 = Factory and save IP
• Query Format: n/a
pvpjdo
• Description: System Manager Settings
• Parameters:
--blkinv (BlackInvalid Mode): 0 = OFF, 1 = ON
--vfd (VFD Brightness): 0..6
--opmode (operation mode):
0 = SingleChannel, 1 = DualChannel, 2 = 3DProcessing
3 = MinDelay, 4 = Quad to Dual
(Note: For the new operating take full effect, you must save
settings and reboot the unit.)