Instruction manual

190 ImagePRO-II • User’s Guide
B. Remote Control Protocol
ImagePRO-II Remote Commands
sáÉï=oÉãçíÉ=`çãã~åÇë
sfaobc
• Description: Video Sync Reference Settings
• Command Format:
VIDREF --hoffset1 (h offsetA) --voffset1 (v offsetA)
--hoffset2 (h offsetB) --voffset2 (v offsetB)
--src (source A) --srcb (source B)
• Parameters:
--hoffset1 (Chan A h offset): (-HTotal/2)...(HTotal/2)
--voffset1 (Chan A v offset): (-VTotal/2)...(VTotal/2)
--hoffset2 (Chan B h offset): (-HTotal/2)...(HTotal/2)
--voffset2 (Chan B v offset): (-VTotal/2)...(VTotal/2)
--src (Chan A lock source): 0-freerun, 1-ext sync, 2-DVI, 3-HD15,
4-HDMI, 5-DP, 6-SDI1, 7-SDI2
--srcb (Chan B lock source): 0-freerun, 1-Channel A
• Query Format: VIDREF [--qall|--qsettings|--qstatus]
• Query Response:Video Reference settings in XML format
sfbt
• Description: View Settings
• Required parameters:
--con (connector)
--ch (channel): Required for --percent or --pixel parameters. Not
required for --units or --save or --recall or --reset
• Parameters:
--con (connector): 0-4
0 = DVI, 1 = HD15, 2 = HDMI, 3 = DP, 4 = SDI1, 5 = SDI2
--ch (channel): 0-1
--units (units): 0 = percent, 1 = pixel
--percent (If values are given in percentages, refer to PANZOOM.help
for parameter details.)
--pixel (If values are given in pixels, refer to RECT
for parameter
details.)
--save (save view settings)
--recall (recall view settings)
--reset (reset view settings)
• Query Format 1 (Unit):
VIEW --con (connector) --ch (channel) --?
• Query Response 1: View Settings in the following format
VIEW --unit (units)