Instruction manual

188 ImagePRO-II • User’s Guide
B. Remote Control Protocol
ImagePRO-II Remote Commands
--s3dModeCmd (s3dMode): [0..6]
0 = Off, 1 = SideBySide, 2 = TopBottom, 3 = Sequential,
4 = LeftRight, 5 = FramePacking
--sspack (sspack): [0..2]
0 = OddEven, 1 = EvenOdd, 2 = EvenEven, 3 = OddOdd
--s3dSyncInvert (0,1)
--s3dSwap (3d swap): [0..2]
0 = LeftRight, 1 = RightLeft, 2 = LeftLeft,
3 = RightRight
• Examples:
UINPUT --con 0 --itype 0 --deint 0
(Update DVI (digital in) input, deinterlacing type to Motion Adaptive
• Query Format:
UINPUT --con (connector) --?
• Query Response: Input Settings in the following format:
UINPUT --deint # --motion # --sync # --sspack # --
lrstatus # --s3Dmode # --s3dSyncInvert #
lìíéìí=oÉãçíÉ=`çãã~åÇë
l`e
• Description: Output Channel settings
• Required parameter: --och (output channel)
• Parameters:
--och (output channel): 0-1
--sharp (sharpness): -10..10
--flicker (flicker filter): 0..20
--strobemode (Strobe mode): 0 = OFF, 1 = ON
--strobeint (Strobe interval): 2..100
--flip (flip mode): 0 = None, 1 = HFlip, 2 = VFlip , 3 = HVFlip
• Query Format:
OCH --och (output channel) --?
• Query Response: Output Channel settings in the following format:
OCH --sharp (sharpness) --flicker (flicker)
--strobemode (Strobe mode) --strobeint
(Strobe interval) --flip (Flip mode)
l`lk
• Description: Output Connector Settings
• Required parameters:
--ocon (output connector), for output connectors