Instruction manual

186 ImagePRO-II • User’s Guide
B. Remote Control Protocol
ImagePRO-II Remote Commands
f`e
• Description: Input Channel settings
• Required parameters:
--con (connector)
--ch (channel)
--itype (input type), only for commands to DVI connector
• Parameters:
--con (connector): 0-5
0 = DVI, 1 = HD15,
2 = HDMI, 3 = DP, 4 = SDI1, 5 = SDI2 (available with the 3D/
Dual Channel option installed)
--ch (channel): 0-1, input channel
--itype (input type): 0 = digital, 1 = analog
--iwin: option to set input window
--hpos (Input Window H Position, pixels)
--vpos (Input Window V Position, pixels)
--hsize (Input Window H Size, pixels)
--vsize (Input Window V Size, pixels)
--mask: option to set the mask window
--left (Mask Left in percentage)
--right (Mask Right in percentage)
--top (Mask Top in percentage)
--bottom (Mask Bottom in percentage)
--at (aspect ratio type): 0-6, see below for aspect ratio numbers
--ar (custom aspect ratio) : 0.25 - 10.00, custom aspect ratio. Aspect
Ratio type must be set to 6. Aspect Ratio types:
0 = 1:1, 1 = 3:2, 2 = 4:3, 3 = 5:4, 4 = 16:10, 5 = 16:9,
6=Custom, use --ar to specify actual aspect ratio.
• Examples:
 ICH --con 3 --ch 0 --at 6 --ar 1.91
(Update DP input, aspect ratio type to Custom, and custom aspect ratio to 1.91)
 ICH --con 0 --itype 0 --ch 0 --iwin --hpos 10
(Update DVI (digital in) input, Input Window H Position to 10)
 ICH --con 1 --ch 0 --mask --left 45.10
(Update HD-15 input, Mask Left by 45.10%)
• Query Format 1 (Aspect ratio):
ICH --con (connector) --ch (channel) --?
Query Response 1: Input Channel Aspect Ratio Setting in the following format
ICH --at (AR type) --ar (Custom AR)
• Query Format 2 (Input window):
ICH --con (connector) --ch (channel) --iwin --?