Instruction manual

ImagePRO-II • User’s Guide 185
B. Remote Control Protocol
ImagePRO-II Remote Commands
fã~ÖÉmolJff=oÉãçíÉ=`çãã~åÇë
This section lists the ImagePRO-II remote commands, sorted by category. Click a
hyperlink in the following list to access the commands for a specific category.
• Input Remote Commands
• Output Remote Commands
• View Remote Commands
• System and Ethernet Remote Commands
• Audio Remote Commands
A second set of remote commands has been carried over from the ImagePRO. For details
of these legacy commands, refer to Legacy Remote Commands
on page 200.
fåéìí=oÉãçíÉ=`çãã~åÇë
asffk
• Description: DVI Input Settings
• Required parameters:
--itype (input type): Required for choosing digital or analog DVI settings.
Note: Some of the following parameters are applicable only for digital and some
only for analog settings.
• Parameters:
--chgtype (change type command): 0 = digital, 1 = analog
--itype (input type): 0 = digital, 1 = analog
--sample (sample mode): 0 = OverSample, 1 = OneToOne (for analog
input only)
--phase (sample phase): [-16..15] (for analog input only)
• Query Format (for analog input only):
DVIIN --itype 1 --?
• Query Response: DVI settings in the following format:
DVIIN --sample (sample mode) --phase (sample phase)
eaNRfk
• Description: HD-15 Input settings
• Parameters:
--sample (sample mode cmd): 0 = OverSample, 1 = OneToOne
--phase (sample phase): [-16..15]
• Query Format (for analog input only):
DVIIN --itype 1 --?
• Query Response: HD-15 settings in the following format:
HD15 --sample (sample mode) --phase (sample phase)