Instruction manual

148 ImagePRO-II • User’s Guide
5. Web Remote Control Operations
Configuring Inputs with the Web App Interface
páòáåÖI=mçëáíáçåáåÖI=~åÇ=j~ëâáåÖ=~å=fã~ÖÉ=
The Input Sizing Adjust page, shown in the following illustration, is divided into two
sections:
• Input Window — In this section, you can adjust the size and position of the image
within the active area.
• Mask — In this section, you can create a mask for one or more edges of the
image.
Figure 5-20. Input Szing Adjust Page
páòáåÖ=~åÇ=mçëáíáçåáåÖ=~å=fã~ÖÉ=ïáíÜ=íÜÉ=tÉÄ=^éé=fåíÉêÑ~ÅÉ
To adjust the size or position of the video inside the active area, go to Setup > Input >
Input Main > Sizing Adjust.
In the Input Window section of the Input Sizing Adjust page, the Size and Pos (Position)
functions allow you to size the image, and then position the resized image within the active
area.
 To change input image size and positioning, use the following procedure:
1. Select H Size to size both the left and right edges simultaneously. Values are in
pixels, ranging from 0 to the maximum number of horizontal pixels. The output
“window” is maintained in both size and aspect ratio.
The default setting for H Size is the current maximum active pixels. Moving the
slider to the left zooms in on the image and expands the image along the
horizontal plane. You can then use the Pos functions to move to the portion of the
image you want to display.
2. Select V Size to size both the top and bottom edges simultaneously. Values are in
lines, from 0 to the maximum number of vertical lines. The output “window” is
maintained in both size and aspect ratio.
The default setting for V Size is the current maximum active lines. Moving the
slider to the left zooms in on the image and expands the image along the vertical.
You can then use the Pos functions to move to the portion of the image you want
to display.