Instruction manual

126 ImagePRO-II • User’s Guide
4. Menu Orientation
Working with Audio
Figure 4-114. Audio Setup Submenu
On this submenu, you can set:
~ Audio test tone. This setting sends out a 1 KHz audio test tone on all
channels that support audio, at a reference 0dB level. The test tone
helps adust the levels in an audio mixer that is receiving audio from the
ImagePRO-II.
~ Analog input audio level. The values are:
• +4 dBu. This is the default setting.
• -10 dBV
~ Analog output audio levels for Channel A and Channel B output (with
the 3D/Dual Channel option installed). The options for each channel are:
• +4 dBu. This is the default setting.
• -10 dBV
~ Output delay for Channel A and Channel B (with the 3D/Dual Channel
option installed). The options for each channel are:
• Auto. This is the default setting.
•0 to 300 ms
~ Output audio sampling rates for Channel A and Channel B (with the
3D/Dual Channel option installed). The options for each channel are:
• 48 KHz. This is the default setting.
• 96 KHz
~ Bit depth for Channel A and Channel B (with the3D/Dual Channel option
installed). The options are:
• 16. This is the default setting for Channel B.
•20
• 24. This is the default setting for Channel A.
• Save Config. Saves your audio configuration settings.
AUDIO SETUP
> In Analog Lvl +4dBu
Out Analog Lvl A +4dBu
Out Analog Lvl B +4dBu
Out Delay A
Auto
Out Delay B
Auto
Out Rate A 48 KHz
Out Rate B 48 KHz
Bit depth A 24
Bit depth B 16
Note
+4 dBu is the recommended setting when working with professional
audio equipment.
When working with consumer audio equipment,
10 dBu is the
recommended setting.