Instruction manual

ImagePRO-II • User’s Guide 117
4. Menu Orientation
Operating the ImagePRO-II in 3D Mode
~ Left/Right. The complete left and right images are displayed on different
output connectors. You can use this option with the following pairs of
connectors:
•The DVI and HDMI connectors, with the DVI as the left image
by default, and the HDMI as the right image by default.
•The SDI 1 and SDI 2 connectors, with SDI1 as the left image by
default and SDI2 as the right image by default.
4) If desired, scroll to 3D Swap to swap the left and right output video.
5) To invert the left and right sync signals, scroll to 3D Sync Invert and select On.
6) 3D Sync Delay allows you to adjust delay times for specific 3D glasses or
systems. The options are 0 to 100, in video lines.
7) When prompted, save your output configurations.
mêçÅÉëëáåÖ=aì~äJpíêÉ~ã=Pa=sáÇÉç
The ImagePRO-II uses two sets of connectors to process dual-stream 3D video:
• DVI and HDMI inputs and outputs
Inputs 1 and 3 (DVI-I and HDMI) work jointly to input separate left and right 3D
signals as two single-link DVI signals, at up to 165 megapixels per second.
By default, these signals are displayed with the left eye on the DVI-I output, and
the right eye on the HDMI output.
• SDI 1 and SDI 2 inputs and outputs
Inputs 5 and 6 (SDI 1 and SDI 2) work jointly to input separate left and right 3D
signals.
By default, these signals are displayed with the left eye on the SDI 1 output, and
the right eye on the SDI 2 output.
For both sets of connectors, you can swap the left and right signals so that, for example,
the right-eye video is displayed on the SDI 1 output and the left-eye video is displayed on
the SDI 2 output.
In dual-stream mode, the inputs in a pair are locked and must be in the same format. You
cannot adjust outputs separately.
pÉííáåÖ=ré==íÜÉ=fã~ÖÉmolJff=íç=aáëéä~ó=aì~äJpíêÉ~ã=Pa=sáÇÉç
 To set up the ImagePRO-II to display dual-stream 3D video, use the following
procedure:
1. Verify that the connector pairs you wish to use are connected — either the DVI-I
and HDMI inputs and outputs, or the SDI 1 and SDI 2 inputs and outputs.
2. On the System Menu, set System Mode to 3D. Save this configuration.
3. On the Output Menu, select 3D Mode and choose a 3D format. The options are:
Side Top/Bottom
Sequential Left/Right
Note
The output 3D Mode must match the input 3D Mode.