Instruction manual

ImagePRO-II • User’s Guide 115
4. Menu Orientation
Operating the ImagePRO-II in 3D Mode
pÉííáåÖ=ré=fåéìíë=íç=aáëéä~ó=páåÖäÉJpíêÉ~ã=Pa=sáÇÉç
 To set up the ImagePRO-II to display single-stream 3D video, use the following
procedure:
1. Select System > System Mode > 3D.
2. When prompted to save this configuration, press SEL.
3. Set up the inputs you want to use. On the Input Menu, select Processing > 3D
Mode. This option sets the packing mode for 3D video, determining how the input
signal is processed and sent to the output display. The available options are:
~ Off. This is the default setting.
~ Side. The left and right images are scaled and displayed side by side on
a single connector.
~ Top/Bottom. Left and right images are scaled and displayed on a single
connector. The left image is on top by default and the right image is on
the bottom by default.
~ Sequential. The left and right images are processed in sequence at up
to 120 Hz -- left then right then left, and so on -- displaying the full image
on one connector.
This option is available on the DVI, DisplayPort and HDMI connectors.
DVI supports formats up to 330 MHz pixels (1920x1200p@120 MHz).
DisplayPort supports formats up to 300 MHz pixels (1920x1080p@120).
HDMI supports formats up to 165 MHz (1280x720p@120).
~ Left/Right. The complete left and right images are displayed on different
output connectors. You can use this option with the following pairs of
connectors:
•The DVI and HDMI connectors, with the DVI as the left image
by default, and the HDMI as the right image by default.
•The SDI 1 and SDI 2 connectors, with SDI1 as the left image by
default and SDI2 as the right image by default.
~ FramePack. This option is a special video timing for HDMI video.
4) If you want to swap the left and right connectors, scroll to 3D Swap. This option
lets you switch default settings, or display only the right image or only the left
image as standard 2D video. The options are:
~ Off. This is the default setting.
Top/Bottom 1920x1080p @23.98 Hz
1920x1080p @24 Hz
1280x720p @50 Hz
1280x720p @59.94 Hz
1280x720p @60 Hz
Sequential Sequential progressive frames up to
2048x1200 @120 Hz (24 bits) on the DVI dual-
link and DisplayPort connectors
Table 4-4. Supported Input/Output Resolutions — Single-Stream 3D Video
Signal Format Resolutions
Note
The 3D Mode for an output must match the 3D Mode for the
corresponding input.