Instruction manual

ImagePRO-II • User’s Guide 111
4. Menu Orientation
Operating the ImagePRO-II in Dual-Channel Mode
Figure 4-105. Zoom/Pan Menu — Dual-Channel Mode (sample)
`êÉ~íáåÖ=~=sáÉï=áå=aì~äJ`Ü~ååÉä=jçÇÉ
 To create a view for a channel in dual-channel mode, use the following procedure:
1. Press the PAN/ZOOM button.
2. On the Zoom/Pan Menu, select a channel. The options are A, B, and All.
If you select All, the settings are available to the inputs on both channels.
3. Adjust the settings as described in Creating a View
on page 78 of this chapter.
4. After making all changes, press SEL. The submenu shown in the following
illustration appears.
Figure 4-106. Save View Submenu — Dual-Channel Mode
5. Press SEL to save the view. You are returned to the Zoom/Pan Menu. The view
you created is available to the inputs on the selected channel or channels.
This save persists across power cycles.
If, after creating a view for a channel, you wish to save the view to the system, you can do
so using the procedure described in Saving a View to the System on page 80 of this
chapter. You can then recall the view to any input on any channel, using the procedure
described in Recalling a System View
on page 81 of this chapter.
_~ÅâáåÖ=ré=~=içÖç=áå=aì~äJ`Ü~ååÉä=jçÇÉ
 To back up a logo to a flash drive in dual-channel system mode, use the following
procedure:
1. On the System Menu, select USB. The USB Backup/Restore Submenu
appears.
2. Select Backup Logo. The USB Backup Logo Submenu appears, as shown in
the following illustration. The navigation cursor is at the Channel field.
ZOOM/PAN A
> Channel A
Zoom H 1280
Zoom V 960
SAVE VIEW
> Channel A
View View1
Save