Instruction manual

ImagePRO-II • User’s Guide 109
4. Menu Orientation
Operating the ImagePRO-II in Dual-Channel Mode
Figure 4-100. Save Output Config Prompt
6. Press SEL at this prompt if you want to save the output format to non-volatile
memory.
The Out Save Config prompt appears, as shown in the following illustration.
Figure 4-101. Out Save Config Prompt
7. In the Channel field, select an option. The choices are A, B, and All.
To save your configuration for use by the outputs on only one channel, select the
channel.
To save your configuration for use by the outputs on both channels, select All.
8. Scroll to Save Config, and press SEL. The “Config Saved” message appears at
the bottom of the prompt.
^ÇàìëíáåÖ=lìíéìí=qáãáåÖ=áå=aì~äJ`Ü~ååÉä=jçÇÉ
In dual-channel mode, the Output > Timing Adjust Submenu includes a field labeled
Channel, as shown in the following illustration.
Figure 4-102. Output Timing Adjust Submenu in Dual-Channel Mode
On this menu, you can adjust timings for a channel independently. All outputs mapped to a
channel take that channel’s timings.
^ÇàìëíáåÖ=lìíéìí=bÑÑÉÅíë=áå=aì~äJ`Ü~ååÉä=jçÇÉ
In dual-channel mode, you can set contrast, brightness, color balance and other effects on
a per-channel basis. All outputs mapped to the channel take these settings. In this system
mode, the Output > Effects Submenu looks like the one in the following illustration.
Save Output Cfg?
> <SEL> = Yes
<ESC> = No
OUT SAVE CONFIG B
> Channel B
Save Config
OUT TIMING ADJUST A
> Channel A
H Total 2200
H Position 192