Instruction manual

ImagePRO-II • User’s Guide 97
4. Menu Orientation
Using a Logo or Internal Black
This section discusses both methods of capturing, deleting, and restoring a logo or internal
black.
In addition to these methods, you can also downloading or restore a logo from a USB flash
drive or from the ImagePRO-II Web Interface. For details, refer to Using a USB Device on
page 88 of this chapter, or Backing Up and Restoring Data with the Web Interface, on
page 132 of Chapter 5.
Please note the following important points regarding the logo:
• After you save a logo, the image remains in memory across power cycles.
• You can de-select the logo on display by pressing one of the input buttons or
BLACK.
• When the LOGO or BLACK button is selected, the PAN/ZOOM button is not
operational.
• When you power up an ImagePRO-II that has a stored logo, the LOGO button is
dimmed.
• When the ImagePRO-II has no stored logo, the output displays black during
transitions.
• You can overwrite a stored logo by capturing a new image.
• If you perform a factory reset, the logo is cleared from memory and cannot be
retrieved.
• When an HDCP-capable source is selected (inputs 1, 3, or 4), you cannot save a
logo image from that source.
• With the 3D/Dual Channel mezzanine installed and the system mode set to
Dual2K, you can save and restore a logo to either channel. For more information,
refer to “Backing Up a Logo in Dual-Channel Mode” and “Restoring a Saved
Logo in Dual-Channel Mode” on page 111.
^Äçìí=íÜÉ=ildl=_ìííçå
The LOGO button states are:
• When selected, the LOGO button is lit.
• If the ImagePRO-II has a stored logo, the LOGO button is backlit when you
power up the system.
• When there is no stored logo, the LOGO button is not lit when you power up.
`~éíìêáåÖ=~=içÖç=rëáåÖ=íÜÉ=ildl=_ìííçå
 To capture a logo using the LOGO button, use the following procedure:
1. Press and hold an input button.
2. Press LOGO.
The system captures the frame from the selected input, and stores the frame in
non-volatile memory. While the capture is in progress:
~ A progress bar and related messages are shown on the display screen.
~ The input button is backlit, and the LOGO button is lit.
aÉíÉÅíáåÖ=~åÇ=`~éíìêáåÖ=~=içÖç=rëáåÖ=íÜÉ=içÖç=jÉåì
The Logo Menu, shown in the following illustration, enables you to capture the source for
LOGO