Instruction manual

90 ImagePRO-II • User’s Guide
4. Menu Orientation
Using the System Menu
A message confirms the restore operation and instructs you to reboot the
ImagePRO-II.
_~ÅâáåÖ=ré=içÖç=cáäÉë
After you capture and save a logo image, you can back it up to a flash drive. With the 3D/
Dual Channel mezzanine installed and the system mode set to Dual2K, you can back up
the image on either channel.
 To back up a logo to a flash drive in standard system mode, use the following
procedure:
1. On the System Menu, select USB. The USB Backup/Restore Submenu
appears.
2. Select Backup Logo. The USB Backup Logo Submenu appears, as shown in
the following illustration. The navigation cursor is at the default logo filename.
Figure 4-79. USB Backup Logo Submenu
3. If you wish to change the name of the backup logo, press SEL. Use the ADJUST
knob to change the name, as described in Saving a Custom Format
on page 75.
Press SEL again when you complete the name change.
4. Scroll to Backup Logo and press SEL.
A message confirms the success of the backup operation.
For information about backing up a logo in dual-channel mode, refer to “Backing
Up a Logo in Dual-Channel Mode” on page 111.
oÉëíçêáåÖ=içÖç=cáäÉë
 To restore a logo file that is stored on a flash drive, use the following procedurein
standard system mode:
1. Insert the flash drive in the ImagePRO-II’s front-panel USB port.
2. From the System Menu, select the USB Backup/Restore Submenu.
3. Select Restore Logo. The USB Restore Logo Submenu appears, as shown in
the following illustration.
Figure 4-80. USB Restore Logo Submenu
Note
You must reboot the ImagePRO-II to use the restored
configuration file.
USB BACKUP LOGO
> LogoBackup1
Backup Logo
(FAT filesystem only)
USB RESTORE LOGO
> Logo1
Restore LOGO
(FAT filesystem only)