Instruction manual

ImagePRO-II • User’s Guide 89
4. Menu Orientation
Using the System Menu
Figure 4-76. USB Backup Config Submenu
3. If you wish to change the default name of the backup configuration, press SEL.
Use the ADJUST knob to change the name, as described in Saving an Input
Configuration on page 48. Press SEL again when you complete the name
change.
4. Scroll to Backup Config and press SEL.
A confirmation message appears when the backup is complete.
If the backup operation fails, the message shown in the following illustration
appears. Check that the flash drive is properly formatted and installed, and try
again.
Figure 4-77. Backup Failed Message
oÉëíçêáåÖ=`çåÑáÖìê~íáçå=cáäÉë
 To restore a system configuration file that is stored on a flash drive, use the following
procedure.
1. Insert the flash drive in the ImagePRO-II’s front-panel USB port.
2. From the System Menu, select the USB Backup/Restore Submenu.
3. Select Restore Config. The USB Restore Config Submenu appears, as shown
in the following illustration.
Figure 4-78. USB Restore Config Submenu
4. Press SEL and scroll through the list of configuration files. When you locate the
file you want, press SEL again.
5. Scroll to Restore Config and press SEL.
USB BACKUP CONFIG
> SysBackup1
Backup Config
(FAT filesystem only)
Backup failed
Please check USB
connection and
retry
USB RESTORE CONFIG
> SysBackup1
Restore Config
(FAT filesystem only)