user manual

FSN Series • User’s Guide • Rev 01 59

2. FSN-1400 Orientation

Card Descriptions

3) Loaded LED

The Loaded LED indicates the status of all FPGAs on the card. Refer to the

“Card LEDs” section on page 64 for details.

4) Universal Output 1

Three connectors are provided for Universal Output 1:

~ 1 x HD15

~ 1 x DVI-I

~ 1 x BNC

Using these connectors, different combinations of outputs can be connected to

the FSN-1400, as outlined below.

Cells with check marks denote the connections required for the indicated format.

* up to 165 MHz

** NTSC, PAL or HD

*** up to 165 MHz (UXGA)

Refer to the “Analog Format Connection Table

” section on page 65 for

additional information on using the HD-15 connector.

5) Universal Output 2

Output connections for Universal Output 2 are identical to Universal Output 1.

Refer to the explanation of Universal Output 1 for details.

Note that test patterns can be assigned to any UOC output, and a raster box can be turned

on or off. In Chapter 5, see the “Output Test Patterns Menu

” section for details.

Note

Multiple outputs on a single UOC channel can be active at the

same time, provided that the selected format is compatible.

For example, 1920 x 1080i @ 59.94 is a compatible format on

all three output connectors.

Table 2-7. UOC connector combinations for selected universal output formats

Connectors

Format BNC DVI-I HD-15

HD-SDI



SD-SDI



DVI * 

CVBS 

Y/C 

YPbPr ** 

RGsB 

RGBS 

RGBHV *** 