user manual

196 FSN Series • User’s Guide • Rev 01
5. Menu Orientation
System Menu
• To change the IP address of a highlighted port, press {Set IP Address} to display
the
IP Address Keypad:
Figure 5-75. IP Address keypad (sample)
Enter the desired IP address using the decimal point as the separator between the
four “octets,” and press
{Enter}.
• To change the Subnet Mask of a highlighted port, press {Set Subnet Mask} to
display the
Subnet Mask Keypad. Enter the desired subnet mask using the
decimal point as the separator between the four “octets,” and press
{Enter}.
• After setting both the IP address and the Subnet Mask, press {Apply} to
complete the procedure.
• To return the highlighted port’s IP address and Subnet Mask to their factory
default values, press
{Restore Default Settings}.
Set IP
Address
192.168.0.4
Set IP Address
Close
7 8 9
4 5 6 Trim -
1
0
2 3
. + / - Enter
Undo
Clear
Trim +
Note
You do not have to enter all three digits in a particular octet.
For example, you can enter
4 instead of 004.
Set
Subnet
Mask
Apply
Restore
Default
Settings