User`s manual

HDM 5049 PLUS HDM 5049 PLUS Installation
Page 3-1
3 HDM 5049 PLUS INSTALLATION
3.1 Precautions
• Keep your original packaging. It is designed for this monitor and is the ideal protection during
transport.
• Do not lift the monitor alone to avoid injury.
• Avoid reflections in the picture tube to reduce eye strain.
• Keep the monitor away from heat sources and provide enough ventilation if it is installed in a
rack or console.
• Keep the monitor away from strong sources of magnetic radiation.
3.2 Rack Mounting
The monitor should be mounted in a 19” rack. Four retaining screws in the handles keep the
monitor in place.
Do not cover or block the ventilation openings in the cover.
3.3 Signal Connection
SERVICE 75E R G B HS/CS VS
POWER
Voltage Range:
100 - 240V AC
LINE
Five BNC connectors are available at the rear of the monitor: R, G, B, HS/CS and VS. When the
monitor is the only monitor connected to the source or the last one in a chain, the 75 ohm
termination switch should be set in the lower position.
To loop-through the video signals, use T- or Y-connectors and place the 75 ohm termination switch
in the upper position.
A Thoma Color Analyzer can be connected to the SERVICE connector using the optional
ThomaLink cable (order number Z345501).
WARNING!