User`s manual

HDM 5049 PLUS Technical Specifications
Page 5-1
5 TECHNICAL SPECIFICATIONS
HDM 5049 PLUS FEATURES
• User-friendly keyboard and OSD
• AKB color stability circuit
• Orbiting pixel shift system
• Automatic Color Alignment
• Password protection
• 19” rack-mountable
• Programmable quick degauss
INPUT CONFIGURATION
RGB Input
• Nominal level: 0.7 Vpp ± 3 dB
• BNC connectors
• 75 ohm termination switch
Sync Input
• Nominal level: 2 Vpp,
• Min. 1 Vpp, max 5 Vpp
• Composite or separate H/V sync
• BNC connectors
• 390 ohm
Communication Input / Output
• Female Sub-D 9-pin connector (RS-232)
for Thoma / Philips Color Analyzer
VIDEO PERFORMANCE RGB DRIVE
• RBG bandwidth: 135 MHz typical
• Pulse rise and fall time: typical 3.5 ns
• Black level stability: 0.5% (0-100% APL)
SCANNING SYSTEMS
Horizontal scanning
• Multisync microprocessor controlled
• Frequency range: 30 - 82 kHz
Vertical scanning
• Frequency range: 48 – 150 Hz
• Minimum blanking: 420 µs
Factory-stored Modes
• 1080L x 1920P, 60 Hz Interlaced
(SMPTE 274M)
• 1035L x 1920P, 60 Hz Interlaced
(SMPTE 240M-260M)
• 720L x 1280P, 60 Hz Non-interlaced
(SMPTE 296M)
• 480L x 704P, 60 Hz Non-interlaced
(SMPTE 293M)
• V
IVALDI 525 lines / 60Hz 4 Pictures Mode
• V
IVALDI 525 lines / 60Hz 1 Picture Full
Screen Mode
VISUAL PERFORMANCE
Picture tube
• Dot-In-Line, diagonal: 19” (17” visible)
• Dot pitch: 0.26 mm
• Transparency: 46%
• Phosphor type: P22, rare-earth (red),
sulfide (blue and green)
• Max. convergence error:
Zone A: 0.3 mm, Zone B: 0.4 mm.
Resolution
• Addressable pixels: 1240
• Focus control: DAF system
Geometry
• Maximum error: 1%
CONTROL
• OSD (On Screen Display) menus
• Direct access buttons for contrast,
brightness, Degauss, Power On/Off
(standby)
• Menu push-buttons
• Power switch at rear side
POWER SUPPLY
• Auto-selection: 90–135 / 195–265 V AC
• Power consumption: 120 W nominal
• Frequency limits: 45 – 65 Hz
ENVIRONMENTAL SPECIFICATIONS
• Temperature range:
Operation: 0 / +45 °C
Storage: -20 / +65 °C
• Altitude: 10,000 ft / 3000 m
• Humidity (relative): 95% maximum, non-
condensing
MAGNETIC IMMUNITY
• Automatic Quick Degauss system (minimum
interval: 10 s)
• Vertical and Axial White Uniformity
correction
PHYSICAL SPECIFICATIONS
• Number of 19” rack units: 8
• Dimensions (without handles):
Width: 438 mm / 17.24 inch
Height: 354 mm / 13.97 inch
Depth: 483 mm / 19.01 inch
Weight: 25 kg / 55.12 lb.
Technical specifications are subject to change without prior notice.