user manual

3. Physical Installation

3. PHYSICAL INS TALLATION

3.1 Installation requirements

Requirements

• The Digitizer should n ot be placed in a built-in installation or enclosure unless proper ventilation is prov ided.

• When using the un it in a multi-unit rack assembly or c losed assembly, the ambient temperature inside the as semb ly may not

exceed the maximum rated ambient tempe rature of the Digitizer. The installation should be such that the amount of air f low

required for safe o peration of the equipment in not com prom ised.

• When building in the Digitizer into a rack with cover door, be aware that a s pace of 8,5 cm is needed between the indicated

reference and the cover door. This space is needed to guide the input cables to the inputs.

Image 3-1

A Reference

• The Digitizer will require that air flows freely in vent holes . Blocking these holes will greatly reduce the reliability of the unit and

lead to the possibility of overheating.

• The Digitizer s hould operate from an AC power sou rce. The Digitizer is equipped w ith Pow er Supply A utoranging from 90 to

264 v olt ( 50–60 Hertz).

• When installed in a rack, the mounting sh ould be such that no hazardous condition is achieved due to uneven mechanical

• When the mains s witch located on the b ack of the Digitizer is not accessible due to rack mounting, the socket outlet s upplying

the rack shall be installed near the equipm ent and be easily ac cess ible or a readily accessible disconnect device shall be

incorporated in the fixed wiring. W hen using a rack in an installation is ad visable to log the serial number of the device and to

activate the warranty figure by registering utilizing the included form.

• Do not place t he Digitizer on an unstable cart, stand or table. The de vice m ay fall, causing serious damage to it.

3.2 Connections

Rear panel inputs/outputs

Image 3-2

A Led-wall out

B Power Switch

C Power input

D Loop in

E Loop out

F Retractable d ust filter

G RS232 in

H Reserved

I RS232 out

J Ethernet LAN connector

K Monitor out

R5976388 D 320 DIGITIZER 0 5112002