User Guide

Connections
Connections
7-2
5975646A BARCOGRAPHICS 8100LC 220496
5975646A BARCOGRAPHICS 8100LC 220496
7-2
The BARCOGRAPHICS 8100LC has modular input facilities. The
input slots can be filled up with the following modules :
Video, S-video (NTSC) input
order no. R9827900
RGBS/RGsB analog input
order no. : R9827910
RGB3S/RG3sB input
order no. : R9827920
Component Video input
order no. : R9827930
The sequence of insertion has no importance. It is even perfectly
possible to insert several input modules of one type.
Note : When using a RCVDS 800, RCVDS05 or VS05, the input
configuration of the projector must be as follows:
Slot 1 : video input module
Slot 2 : RGB analog input module
Slot 3 : Component input module
Input connections.
- Power down the BARCOGRAPHICS 8100LC and disconnect the
power cord from the wall outlet.
- Remove the dummy plate covering the chosen input slot by turning
out both screws.
- Slide the input module in the free slot. Insure the module is seated
correctly in the guide grooves.
- Press on both handles of the input module until the module plug
seats in the connector of the BARCOGRAPHICS 8100LC.
100 - 230 V
9 - 4 A
60 - 50 H z
RS232 OUT
0I
IR-A CKNOW LE DGED
IR-RECEIVED
DIAGNOST ICS
CODE
IR-RECEIVER
- Secure the input module by tightening both retaining screws.
- Reconnect the power cord to the wall outlet and switch on the
projector.
The new installed module can be selected with the digit buttons on
the RCU or the local keypad.
Input module insertion into the
BARCOGRAPHICS 8100LC :
The BARCOGRAPHICS 8100LC has modular input facilities. The
input slots can be filled up with the following modules :
Video, S-video (NTSC) input
order no. R9827900
RGBS/RGsB analog input
order no. : R9827910
RGB3S/RG3sB input
order no. : R9827920
Component Video input
order no. : R9827930
The sequence of insertion has no importance. It is even perfectly
possible to insert several input modules of one type.
Note : When using a RCVDS 800, RCVDS05 or VS05, the input
configuration of the projector must be as follows:
Slot 1 : video input module
Slot 2 : RGB analog input module
Slot 3 : Component input module
Input connections.
- Power down the BARCOGRAPHICS 8100LC and disconnect the
power cord from the wall outlet.
- Remove the dummy plate covering the chosen input slot by turning
out both screws.
- Slide the input module in the free slot. Insure the module is seated
correctly in the guide grooves.
- Press on both handles of the input module until the module plug
seats in the connector of the BARCOGRAPHICS 8100LC.
100 - 230 V
9 - 4 A
60 - 50 H z
RS232 OUT
0I
IR-A CKNOW LE DGED
IR-RECEIVED
DIAGNOST ICS
CODE
IR-RECEIVER
- Secure the input module by tightening both retaining screws.
- Reconnect the power cord to the wall outlet and switch on the
projector.
The new installed module can be selected with the digit buttons on
the RCU or the local keypad.
Input module insertion into the
BARCOGRAPHICS 8100LC :